Dell 745N manual Back-Panel Indicators and Features

Table 2-1. Front-Panel Indicator Codes (continued)

LED Indicator	Description
Hard-drive status indicator	The green hard-drive status indicator lights up when the drive
	is ready and is functioning normally. The status indicator is off
	when the drive is absent and is not configured as part of a RAID
	or non-RAID volume or cannot be detected by the operating
	system or RAID controller.
	The green status indicator blinks when a volume of which the
	drive is a member is rebuilding.
	The amber status indicator blinks when a fault occurs with the
	drive.
NIC1 and NIC2 link indicators	The indicators for the two integrated network adapters light
	green if the network adapters are connected to the network.
	The indicators flash green when data is being transmitted.
Power indicator	The green indicator flashes if AC power is available to the
	system, but the system is not powered on.
	The green indicator is on when the system is powered on.
	If the system is not connected to AC power, the green indicator
	is off.

•The power button provides the ability to soft switch the power cycling to the system.

•The two system identification buttons on the front and back panels can be used to locate a particular system within a rack. When one of these buttons is pushed or the system management software is used to identify the system, the blue system status indicators on the front and back of the system blink. (To stop the indicator from blinking press one of the identification buttons a second time, or use the systems management software.)

The front panel also incorporates a USB connector that is accessible when the bezel is removed. See Figure 2-4.

Back-Panel Indicators and Features

Figure 2-2 shows the back-panel indicators and features and Figure 2-3 shows the indicators for the integrated network adapters. Table 2-2 details the conditions associated with each back-panel indicator code.

Indicators, Messages, and Codes

13