3Connect the following power supply cables: a P3 to the power distribution board
b P2 to the system board connector CN2 c P1 to the system board connector CN3
4Close the system. See "Closing the System" in "Troubleshooting Your System."
Expansion Cards
The system supports up to two PCI expansion cards, which are installed in connectors on a riser board. The upper slot supports PCI
NOTE: The connectors on
Installing an Expansion Card
CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.
1Open the system. See "Opening the System" in Troubleshooting Your System."
2If you are installing a remote access controller card and a daughter card is installed, remove the daughter card. See "Removing a Daughter Card."
3Remove the
4Remove the filler bracket on the slot you will be using.
NOTE: Keep this bracket if you need to remove the expansion card. Filler brackets must be installed over empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
5If you are installing a CERC SATA RAID controller or remote access controller, do the following as appropriate:
•Connect the LED cable to bottom of the RAID controller. See Figure
•Connect the remote access controller cable to the bottom of the remote access controller. See Figure
6Insert the expansion card firmly into the
NOTE: Ensure that the
7Replace the
Installing System Components
61