Dell P40G002 Removing the System Fan, Installing the System Fan, Removing the Display Bezel

Page 17

Removing the System Fan

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a.battery

b.base cover

3.Perform the following steps as shown in the illustration:

a.Disconnect the system-fan cable from its connector on the system board [1].

b.Remove the screws that secure the system fan to the computer [2].

c.Remove the system fan from the computer [3].

Installing the System Fan

1.Place the system fan into its slot on the computer.

2.Tighten the screws to secure the system fan to the computer.

3.Connect the system-fan cable to the computer.

4.Install:

a.base cover

b.battery

5.Follow the procedures in After Working Inside Your computer.

Removing the Display Bezel

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the battery.

3.Pry the edges to release the display bezel from the display assembly.

17

Image 17

Contents Dell Latitude E7450 Page Contents Specifications Contacting Dell Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer After Working Inside Your Computer Docking Your Computer Recommended Tools Removing and Installing ComponentsSystem Overview Follow the procedures in Before Working Inside Your Computer Removing the BatteryRemoving the Base Cover Installing the BatteryFollow the procedures in After Working Inside Your computer Removing the Hard Drive Installing the Base CoverBattery Base cover Removing the Coin-Cell Battery Installing the Hard DriveRemoving the Wwan Card Installing the Coin-Cell BatteryRemoving the Wlan Card Installing the Wwan CardInstalling the Wlan Card Removing the Display Bezel Installing the System FanRemoving the System Fan Removing the Display Panel Installing the Display BezelBattery Display bezel Page Removing the Camera Installing the Display PanelBattery Display bezel Display panel Removing the Keyboard Trim Installing the CameraRemoving the Keyboard Installing the Keyboard TrimBattery Base cover Keyboard trim Removing the Palmrest Installing the KeyboardBattery Base cover Keyboard trim Removing the Speakers Installing the PalmrestBattery Base cover Hard drive Keyboard trim Palmrest Installing the Speaker Removing the Display-Hinge Cover Installing the I/O BoardRemoving the I/O Board Palmrest Keyboard Keyboard trim Base cover Installing the Display-Hinge CoverKeyboard trim Palmrest Battery Base cover Keyboard trim Hard drive Palmrest Removing the Display AssemblyInstalling the Display Assembly Removing the System Board Display assembly Hinge cover Wlan card Installing the System BoardRemoving the Heatsink Installing the HeatsinkRemoving the Power-Connector Port Installing the Power Connector Navigation Keys System SetupBoot Sequence System Setup Options PS2 SATA-0 Enables several security features KEK Hyper-Thread Control Page Post Behavior Wwan Updating the Bios Password Type System and Setup PasswordPage Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsDevice Status Lights Battery Status LightsPage Specifications UMA FHD Discharge 0 C to 70 C 32 F to 122 F AC Adapter Environmental Contacting Dell