Dell P40G002 owner manual Installing the Display Assembly

Page 30

5.Pull the WLAN, WWAN and display-assembly cables from the holes on the base chassis that secure the display assembly to the computer.

6.Perform the following steps as shown in the illustration:

a.Remove the screws that secure the display assembly to the computer [1].

b.Lift the display assembly to remove from the computer [2].

Installing the Display Assembly

1.Route the WWAN, WLAN, and display-assembly cables through their respective routing channels on the base chassis and connect to their connectors.

2.Place the display assembly onto the computer.

3.Tighten the screws to secure the display assembly to the computer.

30

Image 30

Contents Dell Latitude E7450 Page Contents Specifications Contacting Dell Working on Your Computer Before Working Inside Your ComputerTurning Off Your Computer After Working Inside Your Computer Docking Your Computer Removing and Installing Components Recommended ToolsSystem Overview Removing the Battery Follow the procedures in Before Working Inside Your ComputerInstalling the Battery Follow the procedures in After Working Inside Your computerRemoving the Base Cover Installing the Base Cover Battery Base coverRemoving the Hard Drive Installing the Hard Drive Removing the Coin-Cell BatteryInstalling the Coin-Cell Battery Removing the Wwan CardInstalling the Wwan Card Installing the Wlan CardRemoving the Wlan Card Installing the System Fan Removing the System FanRemoving the Display Bezel Installing the Display Bezel Battery Display bezelRemoving the Display Panel Page Installing the Display Panel Battery Display bezel Display panelRemoving the Camera Installing the Camera Removing the Keyboard TrimInstalling the Keyboard Trim Battery Base cover Keyboard trimRemoving the Keyboard Installing the Keyboard Removing the PalmrestBattery Base cover Keyboard trim Installing the Palmrest Battery Base cover Hard drive Keyboard trim PalmrestRemoving the Speakers Installing the Speaker Installing the I/O Board Removing the I/O BoardRemoving the Display-Hinge Cover Installing the Display-Hinge Cover Keyboard trim PalmrestPalmrest Keyboard Keyboard trim Base cover Removing the Display Assembly Battery Base cover Keyboard trim Hard drive PalmrestInstalling the Display Assembly Removing the System Board Installing the System Board Display assembly Hinge cover Wlan cardInstalling the Heatsink Removing the HeatsinkRemoving the Power-Connector Port Installing the Power Connector System Setup Boot SequenceNavigation Keys System Setup Options PS2 SATA-0 Enables several security features KEK Hyper-Thread Control Page Post Behavior Wwan Updating the Bios System and Setup Password Password TypePage Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsBattery Status Lights Device Status LightsPage Specifications UMA FHD Discharge 0 C to 70 C 32 F to 122 F AC Adapter Environmental Contacting Dell