Dell E6500 manual Removing the Display Assembly

Back to Contents Page

Display

Dell™ Latitude™ E6500 Service Manual

Removing the Display Assembly	Display Inverter
Replacing the Display Assembly	Removing the Camera and Microphone Assembly
Removing the Display Bezel	Replacing the Camera and Microphone Assembly
Replacing the Display Bezel	Removing the Latch Hook Assembly
Removing the Display Panel	Replacing the Latch Hook Assembly
Replacing the Display Panel	Removing the Display Cover
Removing the Display Panel Brackets	Replacing the Display Cover
Replacing the Display Panel Brackets

NOTE: Some graphics may vary slightly, depending on whether you ordered a cold-cathode fluorescent lamp (CCFL) display or an LED display.

Removing the Display Assembly

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.

1.Follow the instructions in Before Working on Your Computer.

2.Close the display and turn the computer over.

3.Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).

4.Remove the hinge covers (see Removing the Hinge Covers).

5.Disconnect the display cable, the WPAN cable, and the modem cable.

CAUTION: After unrouting the cables, place all cables to the rear and away from the computer.

6. Unroute the display cable and the wireless cables (WLAN, WWAN, and WPAN).

1	display cable	2	WPAN cable
3	WLAN cable	4	WWAN cable

7. Remove the M2.5 x 5-mm screws from each hinge.

1 M2.5 x 5-mm screws (2)