Dell E6500 manual Removing the Bottom of the Base Assembly, Removing the Base Assembly

Back to Contents Page

Base Assembly

Dell™ Latitude™ E6500 Service Manual

Removing the Bottom of the Base Assembly

Replacing the Bottom of the Base Assembly

Removing the Base Assembly

Replacing the Base Assembly

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.

Removing the Bottom of the Base Assembly

1.Follow the procedures in Before Working on Your Computer.

2.Close the display and turn the computer over.

3.Loosen the M2.5 x 5-mm capture screw.

4.Using the rubber feet for leverage, slide the bottom of the base assembly away from computer, then lift to remove it.

1M2.5 x 5-mm captive screw 2 rubber feet

3bottom of base assembly

Replacing the Bottom of the Base Assembly

1.Slide the bottom of the base assembly into place.

2.Replace the M2.5 x 5-mm captive screw.

Removing the Base Assembly

1.Follow the procedures in Before Working on Your Computer.

2.Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).

3.Remove the system board (see Removing the System Board Assembly).

Replacing the Base Assembly

1.Replace the system board (see Replacing the System Board Assembly).

2.Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly).