Dell E6500 manual Replacing the Processor Module

7. Lift the processor module from the ZIF socket.

Replacing the Processor Module

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.

CAUTION: Do not touch the processor die. Press and hold the processor down on the substrate on which the die is mounted while turning the cam screw to prevent intermittent contact between the cam screw and processor.

CAUTION: Ensure the cam lock is in a fully open position before seating the processor module. You do not have to use force for seating the processor module properly in the ZIF socket. A processor module that is not properly seated can result in an intermittent connection or permanent damage to the microprocessor and ZIF socket.

NOTE: If a new processor is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will receive a new thermal pad along with a tech sheet illustrating proper installation.

1. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor module.

NOTE: The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.

When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the others, the module is not seated properly.

1ZIF-socket cam screw 2 ZIF socket

3pin-1 corner

CAUTION: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.

2.Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.

3.Replace the processor thermal-cooling assembly (see Replacing the Processor Thermal-Cooling Assembly).

4.Replace the fan (see Replacing the Fan).

5.Replace the bottom of the base assembly (see Removing the Bottom of the Base Assembly).

6.Replace the battery (see Replacing the Battery).

Back to Contents Page