8. Disconnect the interposer from the hard drive.
2
1
1 interposer | 2 hard drive |
CHAPTER 4: HARD DRIVE
Replacing the Hard Drive
1.Follow the instructions in “Before You Begin” on page 6.
2.Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
CAUTION: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.
3.Connect the interposer to the hard drive.
4.Place the hard drive in the
5.Replace the four screws that secure the hard drive to the
6.Place the
7.Align and tighten the four captive screws that secure the
8.Replace the compartment door (see “Replacing the Compartment Door” on page 14).
9.Replace the battery pack (see “Replacing the Battery Pack” on page 11).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.
10.Install the operating system for your computer, as needed.
11.Install the drivers and utilities for your computer, as needed.
018/018