10.Turn the palm rest over and release the connector latch on the system board connector.
11.Pull on the
12.Lift the palm rest off the computer.
4
3
2
1
CHAPTER 9: PALM REST
Replacing the Palm Rest
1.Follow the instructions in “Before You Begin” on page 6.
2.Slide the touch pad cable into the system board connector and push down the connector latch to secure the cable to the connector.
3.Press and slide the palm rest into position.
4.Turn the computer over and replace the two screws that secure the palm rest to the computer base.
5.Replace the memory module(s) (see “Replacing the Memory Module(s)” on page 23).
6.Replace the hard drive (see “Replacing the Hard Drive” on page 18).
7.Replace the compartment door (see “Replacing the Compartment Door” on page 14).
8.Replace the battery pack (see “Replacing the Battery Pack” on page 11).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.
1 | touch pad | 3 |
| |
2 | palm rest | 4 | connector latch | 039/ |
|
|
|
| |
|
|
|
| 039 |