Replacing the Consumer IR Board
1.Follow the instructions in “Before You Begin” on page 6.
2.Align the consumer IR board with the guide posts on the computer base.
3.Replace the two screws that secure the consumer IR board to the computer base.
4.Connect the consumer IR board cable to the system board connector.
5.Replace the magnesium cover (see “Replacing the Magnesium Cover” on page 85).
6.Replace the display assembly (see “Replacing the Display Assembly” on page
75).
7.Replace the palm rest (see “Replacing the Palm Rest” on page 39).
8.Replace the keyboard (see “Replacing the Keyboard” on page 35).
CHAPTER 20: CONSUMER IR BOARD
9.Replace the center control cover (see “Replacing the Center Control Cover” on page 31).
10.Replace the memory module(s) (see “Replacing the Memory Module(s)” on page 23).
11.Replace the hard drive (see “Replacing the Hard Drive” on page 18).
12.Replace the compartment door (see “Replacing the Compartment Door” on page 14).
13.Replace the battery pack (see “Replacing the Battery Pack” on page 11).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.
093/093