CNET CNWR-811P manual Macintosh Configuration, Mode

PC Configuration

Macintosh Configuration

The CNWR-811P currently does not support printing from the Macintosh, but you can access the Internet via the CNWR-811P. The procedure is as follows.

1.Open the TCP/IP Control Panel.

2.Select Ethernet from the Connect via pop-up menu.

3.Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field can be left blank.

4.Close the TCP/IP panel, saving your settings.

Note:

If using manually assigned IP addresses instead of DHCP, the only change required is to set the Router Address field to the CNWR-811P's IP Address.

Wireless Configuration

To use the Wireless Access Point in the CNWR-811P, each Wireless Station must have com- patible settings, as follows:

Mode	The mode must be set to Infrastructure.
SSID (ESSID)	This must match the value used on the CNWR-811P. The default value is
	default
	Note! The SSID is case sensitive.
WEP	By default, WEP on the CNWR-811P is disabled.
	• If WEP remains disabled on the CNWR-811P, all stations must have
	WEP disabled.
	• If WEP was enabled on the CNWR-811P, each station must use the
	same WEP settings as the CNWR-811P.

35