Citizen Systems CLP-6401 When fnnn command is executed while Tear is OFF, Priority order

Page 81

Initialization parameter values

Initialization values for print or cut position are described below by each operating mode.

In Native ON

 

 

 

 

Unit: mm (inch)

 

 

 

 

 

 

 

 

Normal

Auto-￿cutter

Peeling

Tear-off

 

Minimum

 

print

 

value

 

 

 

 

 

 

 

 

 

 

 

 

Print position

55.9￿(2.2)

55.9￿(2.2)

55.9￿(2.2)

55.9￿(2.2)

 

12.7￿(0.5)

￿(Onnnn, form

 

 

 

offset)

 

 

 

 

 

 

Cut position ￿(fnnn,

55.9￿(2.2)

86.4

68.6

73.7

 

12.7

feed offset)

 

(3.4)

(2.7)

(2.9)

 

(0.5)

If value lower than the minimum value is set, the initialization value will be set automatically.

6.5.6When "fnnn" command is executed while Tear is OFF

Even with the tear-off OFF, the paper will be fed to the "fnnn"-specified position after printing if an "fnnn > Onnnn" value is set by using the "fnnn" command.

This function can be used in such cases as another device is incorporated in the printer.

6.5.7Priority order

The following three functions (optional) cannot be performed simultaneously.

If commands for those three functions are received simultaneously, they will be executed in the following priority:

1st: Auto-cutting

2nd: Peeling

3rd: Tear-off

6-18

Image 81
Contents CLP-6401 FCC Compliance Statement For American Users EMI Compliance Statement For Canadian Users Important Safety Instructions Page Safety Signs Page General Precautions Precautions When Installing the Printer Chapter Control Panel Chapters in This ManualTable of Contents Chapter Troubleshooting Xii Chapter Setup Confirmation of Carton Contents Front View Part Names and FunctionsInside View Page Side View Connection to Power Connection to a Computer Chapter Control Panel Control Panel Normal Operating Mode LCD/LED Indications and Adjustment ControlsSelf-Test Mode Printer Setup ModePage System Maintenance Mode Page Printer Default Values Preparation for Printing Kinds of Paper Specification of Label and TagPrinting area Units for position and length Reference line and points Paper Setting Roll paper Ribbon Ribbon Setting Head Offset Adjustments Heating element Head Pressure Adjustments Ribbon width Ribbon winding Ribbon feed Tension Section Ribbon Tension AdjustmentsExterior view and part names Adjustable SensorHow to operate adjustable sensor Specification of paper for adjustable sensor Cleaning Troubleshooting Error descriptions and indications Error MessagesCmnd Error indications and corrective actions Page Page Power Troubleshooting Paper Feed Troubleshooting Ribbon Feed Troubleshooting Print Troubleshooting Page Interface Troubleshooting Page Chapter Options Peeler Unit Auto-Cutter UnitPcmcia Memory Card Page Chapter Specifications ・ UCC/EAN Main SpecificationsDescription LCD Description Interface System configurationSerial interface Specification of interfaceFig. Loopback test 3 RS-232C loopback testFig. Buffer in use 4 RS-232C protocolPage Interface pin assignment Parallel interface pin assignment table Without print Outline of Command SystemExample of Connection to a Computer Tear-off when printing Tear-Off Function Turning Tear ON/OFF ・ Paper is fed to the cut position Tear-off when feedingTear-off and type of data Cut position adjustmentsPriority order When fnnn command is executed while Tear is OFF