Citizen Systems PROdot 350 Chapter Loading Media In To The Printer, Paper Thickness Adjustment

Page 13

Chapter 3

Loading Media In To The Printer

Paper Thickness Adjustment

By default, the Prodot 350 printer will detect the thickness of media being used on the first line of each page. You can override the default settings using the control panel and the printer’s configuration settings.

Details of the method of adjusting the configuration settings can be found in Chapter 5 of this manual and in the Prodot 300 manual.

Loading Single Cut Sheets

Turn the printer on.

Then press the PARK/LOAD key to set the paper select lever at the cut-sheet position as shown in the figure below.

Note: You should NOT change this setting manually. Always use the control panel key.

Position the left hand guide in the correct location for the size of paper being used.

Refer to the indications on the top cover where the A4 and Letter size paper sizes are indicated.

- 13 -

Image 13

Contents PROdot Contents Appendix a Introduction Important Safety InstructionsDeclaration of Conformity Trademark AcknowledgementPage Page Automatic Media Thickness Selection Chapter Overview of Additional FeaturesAutomatic Media Straightening Left Edge DetectionUnpacking Chapter InstallationPrinter Location Before Using Your New PrinterParts Identification Inserting And Replacing The Ribbon Cassette Page Chapter Loading Media In To The Printer Paper Thickness AdjustmentLoading Single Cut Sheets Using Tractor Paper Page Adjusting the Sensor Gap Detector Using Passbooks Inserting a Passbook Automatically Adjusting Print Start PositionChapter Printing from your software Setting Up Your Printer To Work With Your SoftwareChapter Control Panel Using The Printer Control PanelBasic Control Panel Operations PARK/LOAD Default Configuration ReportPage Chapter Passbook Printing Passbook Printing ConfigurationPassbook2 Mode Fixed passbook length Passbook1 Mode Automatic Passbook Length DetectionCalculation of PB Length for Passbook2 mode Example program or using Passbook1 mode CLS Width Lprint 255 Lprint CHR$&H1B~A Example program for using Passbook2 modePage Technical Specifications Appendix a Printer SpecificationsAdditional Programming Commands Appendix B Command Code SummarySelect Printhead Impact Force Select paper type cut sheet or fanfold Select head gap adjustment mode passbook modeSelect skip mode Copyright C Citizen Systems Europe GmbH