Citizen Systems PROdot 350 user manual

Page 15

Release the lock lever of the right tractor and open the tractor paper guide. Place the paper on the sprocket pins, then close the paper guide.

Slide the right tractor to left to take up any slack in the paper, then fasten the lock lever to fix the tractor in position as shown.

Align the paper with the print start position.

Release the lock lever of left tractor and move the tractor to the left edge of the tractor paper. Fasten the lock lever to lock the tractor in position.

Open the tractor paper guide and place the paper on the sprocket pins as shown. If you are using pre-printed paper or labels, install them with the printed or labelled side facing upwards

Ensure the tractor paper is in line with the print start position. If the paper is not aligned with the print start position, release the tractor lock levers of the left and right tractors, align the paper, and then fasten the lock lever to lock the tractors.

To tear off the paper, make sure that printed paper is fed to the front table. If not, turn off-line then press PARK/LOAD key.

Hold the edge of paper and pull it to the edge of the top cover as shown. If the perforation of the paper is not at the edge of the top cover, adjust the tear off position, referring to Chapter 5.

- 15 -

Page 14 Page 16
Image 15
Page 14 Page 16
Contents PROdot Contents Appendix a Trademark Acknowledgement Important Safety InstructionsIntroduction Declaration of ConformityPage Page Left Edge Detection Chapter Overview of Additional FeaturesAutomatic Media Thickness Selection Automatic Media StraighteningUnpacking Chapter InstallationPrinter Location Before Using Your New PrinterParts Identification Inserting And Replacing The Ribbon Cassette Page Paper Thickness Adjustment Chapter Loading Media In To The PrinterLoading Single Cut Sheets Using Tractor Paper Page Adjusting the Sensor Gap Detector Using Passbooks Inserting a Passbook Automatically Adjusting Print Start PositionChapter Printing from your software Setting Up Your Printer To Work With Your SoftwareUsing The Printer Control Panel Chapter Control PanelBasic Control Panel Operations PARK/LOAD Default Configuration ReportPage Chapter Passbook Printing Passbook Printing ConfigurationPassbook1 Mode Automatic Passbook Length Detection Passbook2 Mode Fixed passbook lengthCalculation of PB Length for Passbook2 mode Example program or using Passbook1 mode CLS Width Lprint 255 Lprint CHR$&H1B~A Example program for using Passbook2 modePage Technical Specifications Appendix a Printer SpecificationsAppendix B Command Code Summary Additional Programming CommandsSelect Printhead Impact Force Select paper type cut sheet or fanfold Select head gap adjustment mode passbook modeSelect skip mode Copyright C Citizen Systems Europe GmbH
Top Page Image Contents