Citizen Systems PROdot 350 user manual Chapter Passbook Printing, Passbook Printing Configuration

Page 23

Chapter 6

Passbook Printing

Passbook Printing Configuration

To configure the printer to handle vertical passbooks, the following items in the control panel setup menu must be changed:

Head Gap This determines the operation of the media gap sensor. There are 5 options:

Auto One detects the paper thickness when the printer starts printing each page

Auto All detects the paper thickness on each line printed

Fix Pos Fixes the head gap to a particular value as determined by the “Gap Pos” value

Passbook1 is used for measuring the length of the passbook automatically

Passbook2 is used for presetting the length of the passbook using the “PB Length” value.

Gap Pos. This selects the fixed heap gap value when using the “Fix Pos” Head Gap.

PB Length This sets the fixed passbook length in values from 2 inches to 4 inches, in one-sixth inch increments.

Cross Page When enabled, causes the printer to increase the heap gap to the maximum value while the printer skips over the perforations between continuous paper sheets.

Skew Correct Enables or disables the shutter mechanism operation for straightening media not correctly inserted.

- 23 -

Image 23

Contents PROdot Contents Appendix a Trademark Acknowledgement Important Safety InstructionsIntroduction Declaration of ConformityPage Page Left Edge Detection Chapter Overview of Additional FeaturesAutomatic Media Thickness Selection Automatic Media StraighteningUnpacking Chapter InstallationPrinter Location Before Using Your New PrinterParts Identification Inserting And Replacing The Ribbon Cassette Page Loading Single Cut Sheets Paper Thickness AdjustmentChapter Loading Media In To The Printer Using Tractor Paper Page Adjusting the Sensor Gap Detector Using Passbooks Inserting a Passbook Automatically Adjusting Print Start PositionChapter Printing from your software Setting Up Your Printer To Work With Your Software Basic Control Panel Operations Using The Printer Control Panel Chapter Control Panel PARK/LOAD Default Configuration ReportPage Chapter Passbook Printing Passbook Printing ConfigurationCalculation of PB Length for Passbook2 mode Passbook1 Mode Automatic Passbook Length DetectionPassbook2 Mode Fixed passbook length Example program or using Passbook1 mode CLS Width Lprint 255 Lprint CHR$&H1B~A Example program for using Passbook2 modePage Technical Specifications Appendix a Printer SpecificationsSelect Printhead Impact Force Appendix B Command Code SummaryAdditional Programming Commands Select paper type cut sheet or fanfold Select head gap adjustment mode passbook modeSelect skip mode Copyright C Citizen Systems Europe GmbH