
DI-1162/DI-1162M Remote Access Router
♦Hello Interval (1. . 65535) – The length of time (in seconds) between the Hello Packets that the router sends on the interface. This value is advertised in the router’s Hello Packets. It must be the same for all routers attached to a common network. The smaller the Hello Interval, the faster topological changes will be detected, but more OSPF routing protocol traffic will ensue.
♦Dead Interval (1. . 65535) – After ceasing to hear a router’s Hello Packets, the number of seconds before its neighbors declare the router down. This should be some multiple of the Hello Interval. The value must be the same for all the routers attached to a common network.
♦Authentication Key – This configured data allows the authentication procedure to generate and/or verify the authentication field in the OSPF header. This value must be the same for all routers attached to a common network.
♦State – This enables or disables a particular entry.
Bridge Configuration
Bridges are enabled on the Bridge Configuration screen:
The parameter you can set is described below:
♦Bridge Enable – The third option on the Bridge Configuration menu allows you to enable or disable bridging. Press SAVE once you are finished
34