D-Link DI-1162M manual Wan

DI-1162/DI-1162M Remote Access Router

WAN 1

Items in the screen are described as follows:

♦Tx Packets – The total number of valid packets transmitted by the router since the last reset.

♦Tx Bytes – The total number of bytes transmitted by the router.

♦Tx Discard Packets – The number of packets dropped by the router.

♦Tx Error Packets – the number of invalid packets transmitted by the router. This hardware counter shows the sum of Collisions, Abort, and Underrun packets.

♦Tx Underrun Packets – Runt packets. This counter shows the number of packets transmitted by the router that are less than the allowed 64-octet minimum length. Underrun packets occur due to jam signals generated by collisions, backpressure, etc.

♦Tx Lost CTS Packets – The number of Clear To Send packets that were lost by the router.

♦Rx Packets – The total number of packets received by the router.

♦Rx Bytes – The total number of bytes contained in packets received by the router.

♦Rx Unknown Packets – The number of packets received by the router that were of an unsupported protocol.

♦Rx Discard Packets – The number of packets dropped by the router.

♦Rx Error Packets - Number of invalid packets received by the router. This hardware counter shows the sum of NOA, Abort, CRC, Overrun, CD Lost, Framing, and Parity error packets.

♦Rx NOA Packets – Non-Octet Alignment. This counts the number of packets received by the router that did not end on a byte boundary. The receipt of a misaligned packet will generate a single NOA event regardless of the number of misaligned octets in the packet.

♦Rx Abort Packet – The number of packets that were dropped due to user generated breaks in the transmission that occurred while a packet is being received.

♦Rx CRC Packets – The number of packets received that failed the CRC checksum test.

90