DI-1162/DI-1162M Remote Access Router
3.Talk – The router will send adjacent routers it’s own routing table, but will not incorporate routing information from them.
4.Both – The router will incorporate routing information from adjacent routers, and will send adjacent routers it’s own routing table.
♦IP Multicasting – This feature enables or disables the router’s ability to perform IP multicasting. When enabled, the router will perform IGMP. It can also perform DVMRP if this feature is enabled below.
♦Multicast Protocol – If this parameter is set to None, the router will only use the Internet Group Management Protocol (IGMP). If it is set to DVMRP, the router will also use the Distance Vector Multicast Routing Protocol (DVMRP).
♦IGMP Version – Configures the router to use either IGMP version 1 or 2.
♦DHCP Client (LAN) – This feature allows the LAN port to be assigned an IP address from a DHCP server other than the one in the router. This feature should be enabled only for special configurations (such as the presence of a cable modem on the LAN) where you wish the router to work with a device on the network that must act as a DHCP server. Otherwise, this feature should be kept disabled.
♦RIP Spoofing (WAN) – This feature should only be enabled if you have more than one router on your network and this router is providing your WAN connection. In this case, if the WAN connection is dropped due to inactivity and this feature is enabled, RIP packets will be sent to the other routers on the network telling them that data can still be sent to the WAN via this router. Otherwise, the other routers will learn that the WAN link has been disconnected and will no longer forward packets destined for the WAN to this router, causing the packets to be dropped before Bandwidth on Demand has a chance to reestablish the WAN connection.
WAN Frame Relay IP Config
If FRAME_RELAY is selected for the Protocol on WAN 1 or WAN 2 under Interface Configuration, the following screen will appear:
The descriptions for all the fields are the same as in the previous section. Select one of the Frame Relay IP Config items at the bottom of the screen to access the following screen:
26
