D-Link DI-1162M manual LED STATUS/ Function

DI-1162/DI-1162M Remote Access Router

LED		STATUS/ FUNCTION
Power		Lights whenever the router is plugged in, turned on, and thus
		receiving power.
Diag		Lights during the startup Power-On Self-Test (POST) test.
Boot		Lights briefly during startup after the PROM program has
		executed. Indicates a successful boot up.
Run		Should be slowly blinking if the router is functioning properly.
	10/100	This LED is ON for a 100Mbps link, and OFF for a 10Mbps
		link.
	Link/Act	This LED is ON to show a good link to the LAN, and quickly
LAN		flashes to show communication activity on the line.
	Full/Half	This LED is ON for a full-duplex connection, and OFF for
		half-duplex.
	Col	The LED flashes to show transmission collisions on the line.
WANs	Ready	This LED is ON to show a good modem or CSU/DSU link to
		the WAN port.
1 & 2
	Act	This LED flashes to show communication activity on the line.
	Ready	This LED is ON to show a good modem or CSU/DSU link to
Module		the WAN module, or a good link to the LAN port module.
	Act	This LED flashes to show communication activity on the line.

♦Diagnostics RS-232 Serial Port A DB-9 female connector used to connect a console to the router for initial setup and out-of-band management.

♦Wan Ports (1 and 2) Two DB-25 male connectors each of which can be connected to a dial-up (dial in or out) line or a dedicated leased line by multiplexing with a modem or CSU/DSU (Channel Service Unit/ Data Service Unit), respectively.

♦Slot for Add-in Module This slot is able to house any one of the following slide-in expansion modules:

◊A single RJ-45 10/100 Ethernet port

◊Two high-speed serial (async/sync) ports

◊A BRI ISDN module (S/T interface only).

♦LAN Port This jack is a full featured RJ-45 10/100 Ethernet/Fast Ethernet port. This feature allows this port to automatically configure itself to match the settings used by the port it is being connected to. If it is connected

6