DI-1162/DI-1162M Remote Access Router

Bridge Settings

The parameters are described below:

Bridge ID – The Bridge ID is a read-only object composed of the bridge priority and the MAC address. So in the screen above, the Priority is 32768 and the MAC address is zero since it was yet to be entered.

Priority – A Bridge Priority is a read-write object that can be set from 0 to 65535. This is the priority number of the bridge. The value is used in conjunction with the bridge MAC address to set the bridge ID, which in turn is used when determining the root bridge of a multi-bridged network. The root bridge is responsible for processing data packets when network loops occur. The smaller the number set, the higher the bridge priority is. The higher the bridge priority, the more chance the bridge has of becoming the root bridge. Zero is the highest priority.

Port Aging – This is a read-write object that allows you to set the aging time for MAC addresses in a port’s address table. When the time-out figure is reached, the bridge will remove the MAC address.

Max Age – Maximum Age is a read-write object that can be set from 6 to 40 seconds. At the end of the Maximum Age, if a BPDU has still not been received from the Root Bridge, your Switch will start sending its own BPDU to all other switches for permission to become the Root Bridge. If it turns out that your Switch has the lowest Bridge Identifier, it will become the Root Bridge.

Hello Time – Hello Time is a read-write object that can be set from 1 to 10 seconds. This is the interval between two transmissions of BPDU packets sent by the Root Bridge to tell all other switches that it is indeed the Root Bridge. If you set a Hello Time for your Switch, and it is not the Root Bridge, the set Hello Time will be used if and when your Switch becomes the Root Bridge.

Forward Delay – The Forward Delay is a read-write object that can be set from 4 to 30 seconds. This is the time any port on the Switch spends in the listening state while moving from the blocking state to the forwarding state.

Bridge Port Setting:

35

Page 41
Image 41
D-Link DI-1162M manual Bridge Settings