Citizen Systems PROdot 350 user manual

Page 5

to protect it from overheating, do not block or cover these openings. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is provided.

7.This product should be operated from the type of power source indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local power company.

8.This product is equipped with a 3-wire grounding-type plug, a plug having a third (grounding) pin. This plug will only fit into a grounding- type power outlet.

This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding-type plug.

9.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be walked on.

10.Never push objects of any kind into this product though cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.

11.Except as explained elsewhere in this manual, don’t attempt to service this product yourself. Opening and removing those covers that are marked ‘Do Not Remove’ may expose you to dangerous voltage points or other risks. Refer all servicing on those compartments to service personnel.

12.The mains plug on this equipment must be used to disconnect mains power.

Please ensure that the socket outlet is installed near the equipment and shall be easily accessible.

13.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power cord or plug is damaged or frayed.

b.If liquid has been spilled into the product.

c.If the product has been exposed to rain or water.

d.If the product does not operate normally when the operating instruc- tions are followed. Adjust only those controls that are covered by the

-5 -

Image 5
Contents PROdot Contents Appendix a Introduction Important Safety InstructionsDeclaration of Conformity Trademark AcknowledgementPage Page Automatic Media Thickness Selection Chapter Overview of Additional FeaturesAutomatic Media Straightening Left Edge DetectionUnpacking Chapter InstallationPrinter Location Before Using Your New PrinterParts Identification Inserting And Replacing The Ribbon Cassette Page Loading Single Cut Sheets Paper Thickness AdjustmentChapter Loading Media In To The Printer Using Tractor Paper Page Adjusting the Sensor Gap Detector Using Passbooks Inserting a Passbook Automatically Adjusting Print Start PositionChapter Printing from your software Setting Up Your Printer To Work With Your SoftwareBasic Control Panel Operations Using The Printer Control PanelChapter Control Panel PARK/LOAD Default Configuration ReportPage Chapter Passbook Printing Passbook Printing ConfigurationCalculation of PB Length for Passbook2 mode Passbook1 Mode Automatic Passbook Length DetectionPassbook2 Mode Fixed passbook length Example program or using Passbook1 mode CLS Width Lprint 255 Lprint CHR$&H1B~A Example program for using Passbook2 modePage Technical Specifications Appendix a Printer SpecificationsSelect Printhead Impact Force Appendix B Command Code SummaryAdditional Programming Commands Select paper type cut sheet or fanfold Select head gap adjustment mode passbook modeSelect skip mode Copyright C Citizen Systems Europe GmbH