Citizen Systems PROdot 350 user manual Using Passbooks

Page 17

Using Passbooks

Turn the printer on.

Then press the PARK/LOAD key to set the paper select lever at the cut-sheet position as shown in the figure below.

Note: You should NOT change this setting manually. Always use the control panel key.

Position the left hand guide in the

correct location for the size of paper being used.

Before inserting the passbook in to the printer, flatten it as shown in the figure below.

If the binding stitch area is projecting outward when the passbook is opened, flatten it using a pencil or similar as shown in the figure. This is to ensure the passbook is feed smoothly through the printer

and to avoid any damage to the printhead.

Note: Do not feed irregularly shaped passbooks nor passbooks who’s pages are covered in a smooth coating otherwise improper printing and damage may occur.

- 17 -

Image 17
Contents PROdot Contents Appendix a Introduction Important Safety InstructionsDeclaration of Conformity Trademark AcknowledgementPage Page Automatic Media Thickness Selection Chapter Overview of Additional FeaturesAutomatic Media Straightening Left Edge DetectionUnpacking Chapter InstallationPrinter Location Before Using Your New PrinterParts Identification Inserting And Replacing The Ribbon Cassette Page Loading Single Cut Sheets Paper Thickness AdjustmentChapter Loading Media In To The Printer Using Tractor Paper Page Adjusting the Sensor Gap Detector Using Passbooks Inserting a Passbook Automatically Adjusting Print Start PositionChapter Printing from your software Setting Up Your Printer To Work With Your SoftwareBasic Control Panel Operations Using The Printer Control PanelChapter Control Panel PARK/LOAD Default Configuration ReportPage Chapter Passbook Printing Passbook Printing ConfigurationCalculation of PB Length for Passbook2 mode Passbook1 Mode Automatic Passbook Length DetectionPassbook2 Mode Fixed passbook length Example program or using Passbook1 mode CLS Width Lprint 255 Lprint CHR$&H1B~A Example program for using Passbook2 modePage Technical Specifications Appendix a Printer SpecificationsSelect Printhead Impact Force Appendix B Command Code SummaryAdditional Programming Commands Select paper type cut sheet or fanfold Select head gap adjustment mode passbook modeSelect skip mode Copyright C Citizen Systems Europe GmbH