Citizen Systems iDP-460 user manual Rs, Us, Si

[Function]

1. Serial interface 7-bit setting

High pages are specified in all the modes. If this command is received, the

character codes 20H to 7FH will be converted into A0H to FFH. This

command remains valid until the SI command or CAN command is

received.

2. Serial interface 8-bit setting and parallel interface

This command is ignored in the P-250 mode and P-900R mode. In the

other modes, it sets the double width characters(same as the RS command

<IE>H). It prints its subsequent characters as double width characters.

When there is only one character worth of position in a line, it will be

printed in normal width. This attribute remains valid until the SI

command(normal width mode) or CAN command is received.

In the P-200 mode, this attribute is reset to normal width at the beginning

of each line, every time the line is fed.

[See Also]

RS, US, SI

SI

ALL

[Name]

Set Normal Width Mode or Reset Character Code

[Code]

<0F>H

[Function]

This command resets the double width character attribute or high page

setting and prints in normal width or normal character code. The print data

received after this command is printed in normal width or normal character

code.

[Caution]

If double width character has been set by the SO command, the same function

as the US command will be assumed.

[See Also]

RS, US, SO

50

CITIZEN