(2)Changing the Paper
1)Cut off the remaining paper near the entrance to the printer.
2)If the alarm lamp is on, turn it off by pressing the line switch.
3)Feed the paper out of the printer by pressing the LF switch or p ull it out from the paper exit.
4)Install a new paper roll. (Refer to section 6.4 (1) Installing the paper.)
5)When the line switch is pressed again, the printer enters select (on line) status and printing may be resumed once again.
6.5Self Print Function
Your printer has a built in self print function for the purpose of checking print operation without the need for any other external device.
Procedures for Actuating the Self Print Function
[1]Be sure that a paper roll is properly loaded.
[2]Confirm that the inked ribbon is properly installed and turn the power switch off.
[3]Turn the power switch ON while pressing the LF switch, and release the LF switch after the self print operation has begun.
In the above operation, the se print unction will stop automatically when completed.
However, the self print function will not operate without paper when the printer is set for internal process of the paper end detection function.
6.6Paper End Detector
Your printer provides a paper end detection function which is able to detect when the paper is near the end. In addition. two different responses to this situation may be selected.
[1]Issue the PE signal to an external unit(s).
[2]Perform internal processing, whereby the buzzer is sounded and the print operation of your printer is interrupted.
18 | CITIZEN |