CBM America CBM-710, CBM-750 manual Initial Set Command, Inverted character command, Buzzer Command

Page 44

CBM-710/720/730/750 User ’s Manual

(8) Initial Set Command

D8							D1
0	0	0	1	0	0	0	1

DC1 (11)H

The controller is initialized by this command and the following conditions are established.

*Internal input buffer cleared

*Normal character mode selected

*Black color print mode selected

*Skip designation cancelled

*Page length set to 66 lines

*Line feed pitch set to 219 inch (graphic type only)

(9)Inverted character command

D8							D1
0	0	0	1	0	0	1	0	DC2 (12)H

This command specifies inverted characters. By entering this command at the beginning of print data and then sending the data to the controller, all of the following characters will be printed upside down. This command remains valid until, either it is entered again or the initial set command is entered.

(10) Buzzer Command

D8							D1
0	0	0	0	0	1	1	1

BEL (07)H

Command to activate the alarm buzzer for 0.3 second period.

38

CITIZEN

Image 44

Contents Page Declaration of Conformity Important Safety Instructions Sicherheitshinweis Contents 11.1 Introduction FeaturesAccessories Type Classifications CBM-710 23 RSpecifications General SpecificationsCBM-710 CBM-720 Paper Specifications Print FormatBlock Diagram External Appearance and Pars Descriptions CBM-710 External AppearanceCBM-720 External Appearance Front ViewCBM-730 External Appearance CBM-750 External Appearance Part Descriptions Setting and Removing the Paper and Ribbon Covers OperationOpening and Closing the Cutter Unit CBM-720. CBM-750 Installing the Cassette Ribbon Installing and Changing the Paper Installing the PaperCitizen Citizen Procedures for Actuating the Self Print Function Self Print FunctionPaper End Detector Changing the PaperInstallation of the CBM-750 Clearing the Input Buffer Input Buffer BACK-UP FunctionInput Buffer Back-up Parallel Interface SpecificationsConnector Pin Assignment Description of Input/Output Signals Input/Output SignalsElectrical Characteristics Timing Chart Serial Interface DTR Description of Input/Output Signals Error Detection Data CompositionData Receiving Control BufferingOutput DTR, TD Ready Setting DIP Switch DS1 Function SelectionDIP Switch DS2 Serial interface specifications only Slide Switch Setting Serial interface specifications only DIP Switch and Slide Switch LocationsPrint Control Functions Control CodesEnlarged character command Input Data FormatsEnlarged character cancel command Paper feed commandPrint command Clear commandBuzzer Command Initial Set CommandInverted character command Underline Command Graphic Command Graphic Type OnlyPin 13 1/9 inch Line Feed Pitch Set Command Graphic Type14 2/9 inch Line Feed Pitch Set Command Graphic Type Form Feed Command Skip Perforation Cancel Command 2nd byte 4EH 3rd byte N7 N6 N5 N4 N3 N2 N1 Binary digitalFull Cut Command 1st byte Character Code Tables International Character CodesIndividual Country Character Codes Maintenance Maintenance ProceduresExterior InteriorExternal Dimensions CBM-710CBM-720 Paper Winder Unit AW-2 CBM-730 CBM-750 Information Systems Division Head Office