CBM America CBM-730, CBM-710 Enlarged character cancel command, Paper feed command, Print command

Page 43

CBM-710/720/730/750 User ’s Manual

(3) Enlarged character cancel command

D8							D1
0	0	0	0	1	1	1	1

SI (0F)H

This command is used or canceling e enlarge character mode set by SO, and the following data will be printed out in the normal character mode.

(4) Paper feed command

D8							D1
0	0	0	0	1	0	1	0

LF (0A)H

When there is data in the internal print buffer, line feed will be carried out after printing is completed. When the buffer is empty, line feed only will be carried out.

(5) Print command

D8							D1
0	0	0	0	1	1	0	1

CR (0D)H

By means of this command, line feed is performed after printing is completed. In order to accommodate the print data output formats of various computers, the CR function is selectable. (Please refer to 10 (1) DIP Switch Setting)

(6) Clear command

D8							D1
0	0	0	1	1	0	0	0

CAN (18)H

Print data previously entered on the same line can be cleared by the command.

(7) Red color print command
		D8							D1
		0	0	0	1	0	0	1	1

DC3 (13)H

This command specifies red colored characters and all of the characters on one line will be printed in red. Since this command is cancelled after printing one line, it is necessary to use it for each line on whith red printing is desired.

37

CITIZEN

Image 43

Contents Page Declaration of Conformity Important Safety Instructions Sicherheitshinweis Contents 11.1 Accessories FeaturesIntroduction CBM-710 23 R Type ClassificationsGeneral Specifications SpecificationsCBM-710 CBM-720 Print Format Paper SpecificationsBlock Diagram CBM-710 External Appearance External Appearance and Pars DescriptionsFront View CBM-720 External AppearanceCBM-730 External Appearance CBM-750 External Appearance Part Descriptions Operation Setting and Removing the Paper and Ribbon CoversOpening and Closing the Cutter Unit CBM-720. CBM-750 Installing the Cassette Ribbon Installing the Paper Installing and Changing the PaperCitizen Citizen Changing the Paper Procedures for Actuating the Self Print FunctionSelf Print Function Paper End DetectorInstallation of the CBM-750 Input Buffer Back-up Input Buffer BACK-UP FunctionClearing the Input Buffer Connector Pin Assignment SpecificationsParallel Interface Input/Output Signals Description of Input/Output SignalsElectrical Characteristics Timing Chart Serial Interface DTR Description of Input/Output Signals Data Composition Error DetectionBuffering Data Receiving ControlOutput DTR, TD Ready Function Selection Setting DIP Switch DS1DIP Switch DS2 Serial interface specifications only DIP Switch and Slide Switch Locations Slide Switch Setting Serial interface specifications onlyControl Codes Print Control FunctionsInput Data Formats Enlarged character commandClear command Enlarged character cancel commandPaper feed command Print commandInverted character command Initial Set CommandBuzzer Command Graphic Command Graphic Type Only Underline Command14 2/9 inch Line Feed Pitch Set Command Graphic Type 13 1/9 inch Line Feed Pitch Set Command Graphic TypePin Form Feed Command 2nd byte 4EH 3rd byte N7 N6 N5 N4 N3 N2 N1 Binary digital Skip Perforation Cancel CommandFull Cut Command 1st byte International Character Codes Character Code TablesIndividual Country Character Codes Interior MaintenanceMaintenance Procedures ExteriorCBM-710 External DimensionsCBM-720 Paper Winder Unit AW-2 CBM-730 CBM-750 Information Systems Division Head Office