CBM America CBM-720, CBM-710, CBM-750, CBM-730 manual Function Selection, Setting DIP Switch DS1

Page 38

CBM-710/720/730/750 User ’s Manual

10. FUNCTION SELECTION

In order to meet the widest possible range of needs, various conditions can be selected by setting the DIP

switches and slide switches.

(1) Setting DIP Switch DS1

	No.	Function				Off		On		Factory
	No.	Function				Off		On		Setting
										Setting
	1	Auto Cutter				No		Yes		*1

	2									Off
		International country switching				(Refer to the table below)
	3	International country switching				(Refer to the table below)				Off
	3									Off

	4	Input buffer				7K Byte		2 Line		*1

	5	Character direction				Normal		Inverted		*1

	6	CR cord				CR		CR + LF		Off

	7	Mode				Character		Graphic		*1

	8	SEL/DESEL at "power on"				SELECT		DESELECT		Off

	Note : *1) Setting is variable, depending on the type of printer.

	No.	USA		FRANCE			W.GERMANY			ENGLAND

	2	OFF		ON				OFF		ON

	3	OFF		OFF				ON		ON

32

CITIZEN

Image 38

Contents Page Declaration of Conformity Important Safety Instructions Sicherheitshinweis Contents 11.1 Introduction FeaturesAccessories Type Classifications CBM-710 23 RSpecifications General SpecificationsCBM-710 CBM-720 Paper Specifications Print FormatBlock Diagram External Appearance and Pars Descriptions CBM-710 External AppearanceCBM-720 External Appearance Front ViewCBM-730 External Appearance CBM-750 External Appearance Part Descriptions Setting and Removing the Paper and Ribbon Covers OperationOpening and Closing the Cutter Unit CBM-720. CBM-750 Installing the Cassette Ribbon Installing and Changing the Paper Installing the PaperCitizen Citizen Paper End Detector Procedures for Actuating the Self Print FunctionSelf Print Function Changing the PaperInstallation of the CBM-750 Clearing the Input Buffer Input Buffer BACK-UP FunctionInput Buffer Back-up Parallel Interface SpecificationsConnector Pin Assignment Description of Input/Output Signals Input/Output SignalsElectrical Characteristics Timing Chart Serial Interface DTR Description of Input/Output Signals Error Detection Data CompositionData Receiving Control BufferingOutput DTR, TD Ready Setting DIP Switch DS1 Function SelectionDIP Switch DS2 Serial interface specifications only Slide Switch Setting Serial interface specifications only DIP Switch and Slide Switch LocationsPrint Control Functions Control CodesEnlarged character command Input Data FormatsPrint command Enlarged character cancel commandPaper feed command Clear commandBuzzer Command Initial Set CommandInverted character command Underline Command Graphic Command Graphic Type OnlyPin 13 1/9 inch Line Feed Pitch Set Command Graphic Type14 2/9 inch Line Feed Pitch Set Command Graphic Type Form Feed Command Skip Perforation Cancel Command 2nd byte 4EH 3rd byte N7 N6 N5 N4 N3 N2 N1 Binary digitalFull Cut Command 1st byte Character Code Tables International Character CodesIndividual Country Character Codes Exterior MaintenanceMaintenance Procedures InteriorExternal Dimensions CBM-710CBM-720 Paper Winder Unit AW-2 CBM-730 CBM-750 Information Systems Division Head Office