CBM America CBM-720, CBM-710, CBM-750, CBM-730 Input Buffer BACK-UP Function, Input Buffer Back-up

Page 26

CBM-710/720/730/750 User ’s Manual

7. INPUT BUFFER BACK-UP FUNCTION

7.1 Input Buffer Back-up

If the power is turned off, or there is a power failure during printing, the data in the input buffer will be retained. When the power comes back on, the power failure symbol (..... PD) will be printed in red, and then the data which

was interrupted will be printed from the beginning of the line where the interruption occurred.

Note: The input buffer back-up function may not operate properly if the related capacitor is not sufficiently charged. This may be the case if the printer has not been operated for a long period of time. After the printer power switch has been turned on for 10 minutes, the buffer back-up should be effective for approximately 100 hours or more.

7.2 Clearing the Input Buffer

In case it is desired to delete the data in the input buffer, the power switch should be turned on while pressing the LINE switch. When deletion of the buffer is completed the buzzer will sound. Please be sure to continue pressing the LINE switch until that time.

If the printer fails to work properly at the time the power switch turned on, please delete the input buffer as described above before inputting new data.

20

CITIZEN

Image 26

Contents Page Declaration of Conformity Important Safety Instructions Sicherheitshinweis Contents 11.1 Introduction FeaturesAccessories Type Classifications CBM-710 23 RSpecifications General SpecificationsCBM-710 CBM-720 Paper Specifications Print FormatBlock Diagram External Appearance and Pars Descriptions CBM-710 External AppearanceCBM-720 External Appearance Front ViewCBM-730 External Appearance CBM-750 External Appearance Part Descriptions Setting and Removing the Paper and Ribbon Covers OperationOpening and Closing the Cutter Unit CBM-720. CBM-750 Installing the Cassette Ribbon Installing and Changing the Paper Installing the PaperCitizen Citizen Paper End Detector Procedures for Actuating the Self Print FunctionSelf Print Function Changing the PaperInstallation of the CBM-750 Clearing the Input Buffer Input Buffer BACK-UP FunctionInput Buffer Back-up Parallel Interface SpecificationsConnector Pin Assignment Description of Input/Output Signals Input/Output SignalsElectrical Characteristics Timing Chart Serial Interface DTR Description of Input/Output Signals Error Detection Data CompositionData Receiving Control BufferingOutput DTR, TD Ready Setting DIP Switch DS1 Function SelectionDIP Switch DS2 Serial interface specifications only Slide Switch Setting Serial interface specifications only DIP Switch and Slide Switch LocationsPrint Control Functions Control CodesEnlarged character command Input Data FormatsPrint command Enlarged character cancel commandPaper feed command Clear commandBuzzer Command Initial Set CommandInverted character command Underline Command Graphic Command Graphic Type OnlyPin 13 1/9 inch Line Feed Pitch Set Command Graphic Type14 2/9 inch Line Feed Pitch Set Command Graphic Type Form Feed Command Skip Perforation Cancel Command 2nd byte 4EH 3rd byte N7 N6 N5 N4 N3 N2 N1 Binary digitalFull Cut Command 1st byte Character Code Tables International Character CodesIndividual Country Character Codes Exterior MaintenanceMaintenance Procedures InteriorExternal Dimensions CBM-710CBM-720 Paper Winder Unit AW-2 CBM-730 CBM-750 Information Systems Division Head Office