CBM America CBM-720, CBM-710, CBM-750, CBM-730 manual Input Data Formats, Enlarged character command

Page 42

CBM-710/720/730/750 User ’s Manual

11.2 Input Data Formats

(1) Paper feed command for "n" lines
	D8							D1
1st byte	0	0	0	0	1	1	0	0

FF (0C)H + n

2nd byte

D8							D1
	N7	N6	N5	N4	N3	N2	N1

N7 ~ N1 (Binary digits)

When the number of lines to be fed (2hd byte) is written-in following the paper feed command (1st byte), the paper will be fed by the number of lines specified. The number of lines to be fed can be specified from n=1 to 127. If "0" is specified, paper feed will not be carried out. When there is data in the print buffer at the time this co mmand is applied, this data will first to printed out and then line feeding of "n" lines will be performed.

(2) Enlarged character command

D8							D1
0	0	0	0	1	1	1	0

SO (0E)H

The data following this command, are printed out in twice the normal width. This mode will continue until the corresponding cancel command is input, or automatically released after printing one line. Since enlarged characters are twice the normal width, care should be taken to avoid exceeding the column capacity.

36

CITIZEN

Image 42

Contents Page Declaration of Conformity Important Safety Instructions Sicherheitshinweis Contents 11.1 Features AccessoriesIntroduction Type Classifications CBM-710 23 RSpecifications General SpecificationsCBM-710 CBM-720 Paper Specifications Print FormatBlock Diagram External Appearance and Pars Descriptions CBM-710 External AppearanceCBM-720 External Appearance Front ViewCBM-730 External Appearance CBM-750 External Appearance Part Descriptions Setting and Removing the Paper and Ribbon Covers OperationOpening and Closing the Cutter Unit CBM-720. CBM-750 Installing the Cassette Ribbon Installing and Changing the Paper Installing the PaperCitizen Citizen Paper End Detector Procedures for Actuating the Self Print FunctionSelf Print Function Changing the PaperInstallation of the CBM-750 Input Buffer BACK-UP Function Input Buffer Back-upClearing the Input Buffer Specifications Connector Pin AssignmentParallel Interface Description of Input/Output Signals Input/Output SignalsElectrical Characteristics Timing Chart Serial Interface DTR Description of Input/Output Signals Error Detection Data CompositionData Receiving Control BufferingOutput DTR, TD Ready Setting DIP Switch DS1 Function SelectionDIP Switch DS2 Serial interface specifications only Slide Switch Setting Serial interface specifications only DIP Switch and Slide Switch LocationsPrint Control Functions Control CodesEnlarged character command Input Data FormatsPrint command Enlarged character cancel commandPaper feed command Clear commandInitial Set Command Inverted character commandBuzzer Command Underline Command Graphic Command Graphic Type Only13 1/9 inch Line Feed Pitch Set Command Graphic Type 14 2/9 inch Line Feed Pitch Set Command Graphic TypePin Form Feed Command Skip Perforation Cancel Command 2nd byte 4EH 3rd byte N7 N6 N5 N4 N3 N2 N1 Binary digitalFull Cut Command 1st byte Character Code Tables International Character CodesIndividual Country Character Codes Exterior MaintenanceMaintenance Procedures InteriorExternal Dimensions CBM-710CBM-720 Paper Winder Unit AW-2 CBM-730 CBM-750 Information Systems Division Head Office