AMCC 9550SX-8LP manual If you have a 12-port or 16-port 9550SX

Page 33

Installation Instructions

Bottom clip

Figure 27. Pressing down gently on the battery unit flexes the holder slightly so that the bottom clip can be inserted

If you have a 12-port or 16-port 9550SX:

aInsert the clips on the top of the battery module into the holes on the controller.

Figure 28. Attaching the battery module to the full-height controller

www.3ware.com

29

Image 33

Contents 3ware Copyright TrademarksDisclaimer Table of Contents Appendix Technical Support Before You Begin Contents of PackageOther Documentation Installation ConsiderationsWhether to Use the LED Status Connector Safety Factors Personal SafetyWhat You Need Tools and Equipment Protecting Equipment and Data 9550SX RAID Controller Cards 9550SX 8-Port with Standard Sata Connectors9550SX 12-Port with Standard Sata Connectors 9550SX 4-Port with Standard Sata Connectors9550SX 16-Port with Multilane Internal Sata Connectors 9550SX 12-Port with Multilane Internal Sata ConnectorsTo connect Sata cables to the controller Installing a Serial ATA RAID ControllerSata Cables Being Inserted Into Port To install the controller in the computerInserting Controller Into PCI Slot To connect the Sata cables to the drives Sata Cable Connecting to DriveMultilane Serial ATA Cable InfiniBand 4x, SFF-8470 9550SX-12MIMultilane Cable Serial ATA SFF-8087 9550SX-16MLPage To install the drives LED connector details Connecting Drive Activity LED IndicatorsPort 3ware 9550SX-12 Serial ATA RAID Controller Additional Details About the LED Status Connectors LED Indicator Pin Positions Check Installation and Close the Case Configure your RAID ArraysFinishing Up Installing an Amcc 3ware 9550SX RAID Controller Installing the Battery Backup Unit Tools and equipment required Installation OverviewPoints of connection on the half-height controller Removing the head from the plastic post Installation InstructionsPress down gently until the BBU is seated If you have a 4-port or 8-port 9550SX If you have a 12-port or 16-port 9550SX Shows the BBU fully installed on 3ware controllers BBU installed on controllers Replacing the Battery Removing the battery module Removing the power cable from the BBU module Feedback on this manual Sales and ordering informationAppendix Technical Support