AMCC 9550SX-8LP manual If you have a 4-port or 8-port 9550SX

Page 32

Chapter 2. Installing the Battery Backup Unit

5If you have a 4-port or 8-port 9550SX:

a Hook the clips on the top of the battery module over the slots on the top edge of the controller.

Figure 25. Clips on the battery module hook over slots on the top edge of the half-height controller

Figure 26. Attaching the battery module to the half-height controller

bPress down gently on the top of the battery unit so that the battery holder flexes slightly and the clip on the bottom slips over the slot on the bottom edge of the controller.

283ware 9550SX Serial ATA RAID Controller Quick Install Guide

Image 32

Contents 3ware Disclaimer CopyrightTrademarks Table of Contents Appendix Technical Support Contents of Package Before You BeginInstallation Considerations Other DocumentationWhether to Use the LED Status Connector What You Need Tools and Equipment Safety FactorsPersonal Safety Protecting Equipment and Data 9550SX 8-Port with Standard Sata Connectors 9550SX RAID Controller Cards9550SX 4-Port with Standard Sata Connectors 9550SX 12-Port with Standard Sata Connectors9550SX 12-Port with Multilane Internal Sata Connectors 9550SX 16-Port with Multilane Internal Sata ConnectorsInstalling a Serial ATA RAID Controller To connect Sata cables to the controllerTo install the controller in the computer Sata Cables Being Inserted Into PortInserting Controller Into PCI Slot Sata Cable Connecting to Drive To connect the Sata cables to the drives9550SX-12MI Multilane Serial ATA Cable InfiniBand 4x, SFF-84709550SX-16ML Multilane Cable Serial ATA SFF-8087Page To install the drives Connecting Drive Activity LED Indicators LED connector detailsPort 3ware 9550SX-12 Serial ATA RAID Controller Additional Details About the LED Status Connectors LED Indicator Pin Positions Finishing Up Check Installation and Close the CaseConfigure your RAID Arrays Installing an Amcc 3ware 9550SX RAID Controller Installing the Battery Backup Unit Installation Overview Tools and equipment requiredPoints of connection on the half-height controller Installation Instructions Removing the head from the plastic postPress down gently until the BBU is seated If you have a 4-port or 8-port 9550SX If you have a 12-port or 16-port 9550SX Shows the BBU fully installed on 3ware controllers BBU installed on controllers Replacing the Battery Removing the battery module Removing the power cable from the BBU module Sales and ordering information Feedback on this manualAppendix Technical Support