Adapter Configuration
of the patterns, it will get a default priority.
There is a set of
3.4.8Security Configuration
The configuration page allows you to change the password. Type your new pass- word and confirm by typing it in a second time. If both fields are left empty, the password will be disabled (the message ‘No password installed’ will be shown). You can turn the password protection back on at any time by simply entering a pass- word, as described above..
26
Factory reset will restore the adapter‘s default settings. The system will ask for the password, which is “betera“. Then click OK. The adapter will restart with the following configuration:
-IP address = 10.10.1.69
-Configuration interface password = paterna
-Factory reset password = betera
-Device type is Automatic EP/AP
-Network Identifier is blank
-No encryption and no VLAN settings
3.4.9 Hardware Reset
Clicking on this button will restart your adapter. The configuration will remain the same, and any changes made in the Network Configuration section will be applied. This means that if you’ve changed the IP address, the adapter will restart with the new IP address.