Adapter Configuration
3.4 Change Configuration Page
3.4.1 Overview
The configuration pages allow you to change the settings on the wall mount adapter. Any parameters changed here will be stored in the wall mount adapter‘s permanent memory, and at the next startup, will be activated automatically. Any changes will take effect immediately after startup, with the exception of the Network Configuration settings (these require a restart of the wall mount adapter).
The configuration is divided into two sections: “Basic settings” and “Advanced settings.”
16
Notes :
•A different IP must be set for each adapter on the network. The adapter’s IP does not need to be in the same range as the PC, except when trying to change the adapter’s settings on the configuration page (10.10.X.X and netmask 255.255.0.0 for an adapter with the default factory settings).
•The adapter’s netmask can also be changed, for example to a type C (255.255.255.0) if necessary. This is a more advanced option, which you may ignore if you’re not familiar with it.