Corinex Global GameNet manual Powerline Domain

Page 45

Network Configuration

When to use this filter:

•When you want to isolate a Powerline test network from the rest of the electrical grid, either because you don’t want the Powerline signal from the test network to go out and disrupt other adapters, or because you want to isolate this network from the noise, or other traffic, in the rest of the electrical grid. This setup is illustrated in the picture below.

Powerline Domain

Corinex AV200 Powerline Wall Mount F

Corinex AV200 Powerline Wall Mount F

	Power Strip
No Noise on this side
No Powerline signal on this side	Prefilter
Corinex	Powerline
Noise	Powerline
Filter

•When you want to isolate the electrical noise produced by some household appliance, because this noise falls in the PLC band and disrupts the signal from the adapters. This setup is illustrated in the picture below.

Noisy Appliance

43

Corinex AV200 Powerline Wall Mount F

Corinex AV200 Powerline Wall Mount F

CorinexPow
NoiseFilter	erline

Powerline Communication

Corinex GameNet

Image 45

Contents Manual Corinex AV200 Powerline Ethernet Wall Mount F Corinex GameNet CopyrightCorinex Communications Corporation End User License AgreementRegistration and Warranty Contents Introduction Enables peripheral- and printer sharingOverview About this ManualPackage Contents InstallationSystem Requirements Physical DescriptionFunctional Description Factory Reset ETH LED LED Definitions VPI LEDConnecting the Wall Mount Adapter Technical SpecificationsInterface EMC limitsAdapter Configuration PasswordAdapter Configuration Main System Information Additional InformationPHY Status Priority Status Overview Change ConfigurationBasic Settings MAC Configuration Advanced ConfigurationWith each other Types and their Network Identifiers Network Id Home PHY Configuration Adapter Configuration Network ConfigurationMulticast Configuration Priority Configuration Adapter Configuration Vlan ConfigurationAdapter Configuration Trigger Hardware Reset Security ConfigurationAdapter Configuration Flash Upgrade Firmware upgrade using a Tftp ServerOpen TFTPD32 Corinex GameNet Internet Configuring Video ApplicationsPattern 1 and Class Priority Firmware UpdateVideo Network Setups Video Network SetupsIntroduction Network ScenariosSingle-Network Scenarios Internet Multi-Network ScenariosTwo Networks on the Same Circuit Two Networks on Different CircuitsNetwork Configuration Setting an IP Address on your ComputerSetting Up a Static IP in Windows XP Corinex GameNet Setting up a static IP in Windows Network Configuration Setting Up a Static IP in Linux Network Configuration Setting up a static IP in Mac OS Network Configuration Improving Network Performance Checking Network Performance Using Powerline FiltersPowerline Domain Troubleshooting Guide Wall Mount adapters