DFI 40800950 manual Power Supply, Floppy Drive

Page 81

Troubleshooting

The picture seems to be constantly moving.

1.The monitor has lost its vertical sync. Adjust the monitor’s vertical sync.

2.Move away any objects, such as another monitor or fan, that may be creating a magnetic field around the display.

3.Make sure your video card’s output frequencies are supported by this monitor.

The screen seems to be constantly wavering.

1.If the monitor is close to another monitor, the adjacent monitor may need to be turned off. Fluorescent lights adjacent to the monitor may also cause screen wavering.

Power Supply

When the computer is turned on, nothing happens.

1.Check that one end of the AC power cord is plugged into a live outlet and the other end properly plugged into the back of the system.

2.Make sure that the voltage selection switch on the back panel is set for the correct type of voltage you are using.

3.The power cord may have a “short” or “open”. Inspect the cord and install a new one if necessary.

Floppy Drive

The computer cannot access the floppy drive.

1.The floppy diskette may not be formatted. Format the diskette and try again.

2.The diskette may be write-protected. Use a diskette that is not write-protected.

3.You may be writing to the wrong drive. Check the path statement to make sure you are writing to the targeted drive.

4.There is not enough space left on the diskette. Use another diskette with adequate storage space.

C

81

Image 81
Contents 40800950 PC64Copyright TrademarksAll Rights Reserved FCC and DOC Statement on Class B Table of Contents Appendix B System Error Messages Appendix a Using the Suspend to RAM FunctionAppendix C Troubleshooting Supported SoftwaresFeatures and Specifications FeaturesIntroduction Onboard PCI Audio Features Aureal AU8810 ATX Double Deck Ports PC 99 color-coded connectorsExpansion Slots PCI Bus Master IDE Controller ConnectorsIrDA Interface USB PortsIntelligence System Health Monitor FunctionsDesktop Management Interface DMI Automatic CPU/Chassis Fan OffRTC Timer to Power-on the System Dual Function Power ButtonWake-On-Ring Wake-On-LAN ReadyAC Power Failure Recovery Year 2000 CompliantSupports hardware Y2K function Virus Protection Package ChecklistSystem Board Layout Hardware InstallationSystem Memory Determining the Maximum System Memory Size Important Installation InstructionsHardware Installation Installing the Rimmtm Module Installing the Processor Processor InstallationSlide Slit URM’s tab Removing the ProcessorSlide Tab Jumper Settings for Clearing Cmos Data Jumper Settings for Wake-On-Keyboard/ Wake-On-Mouse Type Y and press EnterWake-On-Keyboard/Wake-On-Mouse Jumper JP1 On Disable DefaultSystem’s Beep Message Output Select Jumper JP8 Ports and Connectors Serial Ports2 PS/2 Mouse and PS/2 Keyboard Ports Floppy Disk Drive Connector Hardware Installation Parallel PortConnecting the Floppy Disk Drive Cable IDE Disk Drive ConnectorConnecting the IDE Disk Drive Cable Cable aligned with pin 1 of the drive edge connectorsUniversal Serial Bus Ports Adding a Second IDE Disk DriveGround Hardware Installation IrDA ConnectorHardware Installation CPU Fan Connector Chassis Fan ConnectorPin Function Ground On/Off Sense Thermal Sensor Connector Hardware Installation Second Chassis Fan ConnectorAudio Jacks Hardware Installation Game/MIDI PortLine-out Jack J8 Lime Line-in Jack J12 Light BlueVideo-In, AUX-In and CD-In Hardware Installation Internal Audio ConnectorsPin Function Left audio channel Ground Modem-out from modem Ground Modem-in to modemHardware Installation Wake-On-LAN Connector Ground RI# Hardware Installation Wake-On-Ring ConnectorGround Chassis signal +5V Hardware Installation Chassis Open ConnectorRimm Standby Power LED Hardware Installation RIMM/PCI Standby Power LEDPCI Standby Power LED 3VSB Standby for PCI jumper JP7Hardware Installation Power Connector Ground +5V+12V +5V Hardware Installation Front Panel LEDs and Switches HD-LED Standard Cmos Features Award Bios Setup UtilityWhen you press Del, the main menu screen will appear Basic Input/Output SystemDate TimeIDE HDD Auto Detection IDE Primary/Secondary Master/Slave Access ModeCapacity Drive a and Drive BBase Memory Halt OnExtended Memory Total MemoryVirus Warning Award Bios Setup Utility Advanced Bios FeaturesCPU L1 Cache and CPU L2 Cache Quick Power On Self TestCPU L2 Cache ECC Checking Processor Serial NumberBoot Up NumLock Status Boot Up Floppy SeekTypematic Rate Setting Typematic Delay MsecSecurity Option OS Select for Dram 64MBHDD S.M.A.R.T. Capability Award Bios Setup Utility Advanced Chipset Features Dram Data Integrity ModeRimm Module Used Video Bios Cacheable System Bios CacheableDelayed Transaction Video RAM CacheableAward Bios Setup Utility Integrated Peripherals On-Chip Primary PCI IDE and On-Chip Secondary PCI IDEIDE Primary Master/Slave PIO and IDE Secondary Master/Slave USB Controller IDE HDD Block ModeUSB Keyboard Support Init Display FirstKeyboard/Mouse Power On Onboard FDC Controller UART2 Mode SelectOnboard Serial Port 1 and Onboard Serial Port RxD, TxD ActiveParallel Port Mode IR Transmission DelayEPP Mode Select ECP Mode Use DMAPower Management Setup Acpi FunctionAcpi Suspend Type Suspend Mode Power ManagementHDD Power Down Video Off MethodResume on PCI Event Soft-Off by PWR-BTTNResume On Ring Resume On LANResume On Alarm Date of Month AlarmTime hhmmss Alarm Award Bios Setup Utility 6 PnP/PCI Configurations Reset Configuration DataResources Controlled By IRQ Resources SpecificationPCI/VGA Palette Snoop PCI IRQ AssignmentAward Bios Setup Utility System Health Monitor This field shows the voltage of the processor+1.5V, +3.3V, +5V, +12V, -12V, Vbat V and 5VSB Award Bios Setup Utility CPU Frequency Control CPU Clock RatioCPU Host/PCI Clock Load Fail-Safe Defaults MethodSpread Spectrum Set Supervisor Password Award Bios Setup Utility Load Optimized DefaultsAward Bios Setup Utility Set User Password Save & Exit SetupExit Without Saving Desktop Management Interface DMI Supported SoftwaresRunning the DMI Utility Edit DMI Supported Softwares Using the DMI UtilitySupported Softwares Add DMI Load DMI FileSave DMI File Hardware Doctor Utility Intel 820 INF Update Utility for Windows 95/98IDE, USB and Firmware Hub Patch Utility for Intel Sound DriverSoftware License Agreement screen will appear. Click Yes Aureal Vortex Player for Windows 95/98 Drivers and Utilities Installation Notes Intel Ultra ATA Storage Device for Windows 98/NTMicrosoft DirectX 6.1 for Windows 95/98 Supported Softwares Using the Suspend to RAM Function Using the Suspend to RAM FunctionUsing the Suspend to RAM Function Using the Suspend to RAM Function Using the Suspend to RAM Function System Error Message Error MessagesCmos battery is no longer functional. It should be replaced Post BeepBios ROM checksum error System halted Keyboard error or no keyboard presentFloppy Disks fail Hard Disks failTroubleshooting Checklist TroubleshootingMonitor/Display Floppy Drive Power SupplyHard disk failure Troubleshooting Hard DriveTroubleshooting Serial Port KeyboardSystem Board