2
Hardware Installation
2.7.18 RIMM/PCI Standby Power LED
RIMM Standby Power LED
This LED will turn red when the system’s power is on or when it is in the Suspend state (Power On Suspend or Suspend to RAM). It will turn green when the system is in the
PCI Standby Power LED
This LED will turn red when the system is in the
3.3VSB Standby for PCI (jumper JP7)
The default setting of jumper JP7 is On. It provides 3.3VSB Standby power to the PCI slots. If you are using a PCI modem card that does not comply to the PCI 2.2 specification, please set this jumper to Off. The PCI Standby Power LED’s light will subsequently turn off.
1 21 2
|
|
|
|
|
|
| On | Off | |||
(default) |
|
|
Important:
Lighted LEDs (red) serve as a reminder that you must power- off the system then turn off the power supply’s switch or unplug the power cord prior to installing any RIMM or
36