JDS Uniphase RS-232 operation manual Viewing Current Network Settings

Page 6

Viewing Current Network Settings

You can use the “:netinfo=” command to view the current network settings of the Web Xpander using WinEVM. From the MegaController screen, click ASCII and send the command “:netinfo=” (no quotes) out of the controller to COM1. The network settings should appear in the MegaController log window.

If your PC and Web Xpander are connected through a Cable/DSL router and your PC and router are already configured to use addresses in the range displayed, open a web browser and type “http://” followed by the IP Address displayed. (example: http://192.168.0.5) in the address bar and press Enter. If everything is configured properly, you should be prompted for a username and password to access the Web Xpander. The default username and password are both “webx”.

Image 6

Contents Web Xpander Web Xpander What’s Included Installing the Web XpanderWelcome to Web Xpander What You NeedNetwork Connection Network Configuration Viewing Current Network Settings Manually Configuring Web Xpander Network Settings Command Description ExampleWeb Pages LightingX10 Digital Analog Relay Timer Ascii MSG LOG TEL LOG Settings Auto Page RefreshWeb Xpander Labeler ConfigurationLoad Default Labels Importing and Sending Device LabelsAppendix a Web Xpander Commands Description Example Enables or disables Smtp Authentication Appendix B Sending Email with the Web XpanderAppendix C Managing a Dynamic Home Internet Address Appendix D Ethernet to Serial Bridge Functionality Page Page Appendix F Performing a Firmware Update on the Web Xpander Page Page Page Advanced Appendix H Internet Time Synchronization Appendix I Advanced WebXpander URL Commands Example Event Disable Webx Appendix K Web Xpander Firmware Release History Page Page