JDS Uniphase RS-232 operation manual

Page 23

10-pin programming connector

Properly attached Rabbit

Programming Cable

Using the Rabbit Field Utility

1.Start the Rabbit Field Utility located on the Start menu in the Web Xpander folder (labeled WebX Firmware Utility)

2.Select Setup, Communications from the main menu

3.Select “Use Serial Connection”, Baud Rate: 115200, and the COM port you have attached the programming cable to.

4.Uncheck both check boxes labeled “Enable Processor Detection” and “Use USB to Serial Converter”

5.Click OK to save these changes and return to the main window.

Image 23

Contents Web Xpander Web Xpander What You Need Installing the Web XpanderWelcome to Web Xpander What’s IncludedNetwork Connection Network Configuration Viewing Current Network Settings Command Description Example Manually Configuring Web Xpander Network SettingsLighting Web PagesX10 Digital Analog Relay Timer Ascii MSG LOG TEL LOG Auto Page Refresh SettingsImporting and Sending Device Labels ConfigurationLoad Default Labels Web Xpander LabelerAppendix a Web Xpander Commands Description Example Enables or disables Appendix B Sending Email with the Web Xpander Smtp AuthenticationAppendix C Managing a Dynamic Home Internet Address Appendix D Ethernet to Serial Bridge Functionality Page Page Appendix F Performing a Firmware Update on the Web Xpander Page Page Page Advanced Appendix H Internet Time Synchronization Appendix I Advanced WebXpander URL Commands Example Event Disable Webx Appendix K Web Xpander Firmware Release History Page Page