Minolta 0990-7701-02 user manual Adobe PostScript ROM Simm Option Setting-Up

12

Installation CHAPTER 1

3. Setting-Up

Adobe PostScript ROM SIMM (Option) Setting-Up

PRECAUTION

-This printer is equipped with a socket for the installation of an Adobe PostScript ROM SIMM. When the printer is equipped with an Adobe PostScript ROM SIMM, it can function as a PostScript printer.

CAUTION

-Before opening the optional packages or handling the options, briefly touch the metal part of the printer to remove any electrostatic charge from your body.

-When options are taken out of their conductive bags or off their mats, hold them by their edges to avoid touching the terminals or the patterned surfaces.

-When the Controller board is taken out of the printer, hold it by the edges to avoid touching the terminals or the patterned surfaces.

-After removing the options or Controller board, be sure to place it on an anti-static mat or a piece of aluminum foil.

1

2

-Turn the printer OFF.

Power Switch

-Disconnect the cable from the interface connector (Parallel or Serial) or network connector (10BASE-T or 10BASE-2) on the back of the printer.

3

4

-Remove the four screws that secure the controller board on the back of the printer.

-Slide out the controller board.

NOTE

-When the Controller board is taken out of the printer, hold it by the edges to avoid touching the terminals or the patterned surfaces.

-After removing the options or Controller board, be sure to place it on an anti-static mat or a piece of aluminum foil.