1.6 COMMUNICATION PORT
The UPS provides an RS232 serial port to communicate with a host computer. The host computer can monitor the UPS through this RS232 communication port.
The data format of RS232 is as follows:
Baud Rate : 2400 bps
Data Length : 8 bits
Ending Code : 1 bit
Parity Bit : none
1.7 RS-232 IINTERFACE
The following is the pin assignment and description of
Pin # | Description | I/O |
2 | RS232 Rx | input |
3 | RS232 Tx | output |
5 | Ground | input |
2. INSTALLATION AND OPERATION
2.1 UNPACKING AND INSPECTION
Examine the packing carton for damage. Notify the carrier immediately if damage is present. Retain the packing carton for future use.
2.2 INSTALLATION
The UPS should be installed by professional service personnel. To prevent an overbalance of this equipent, the supporter must be mounted at the bottom of the enclosure. Please install the supporter to the UPS at the bottom side with six screws (see Figure 1). Install the supporter at the bottom of the UPS. With the installation of the supporter, tipping of the UPS should be prevented. The
Notes:
●The UPS should be placed in a flat location with a distance of at least 10cm from the wall to the vent. In addition, keep the UPS away from
●Do not place any objects on the top of the UPS.
●The function of an alarm silence is available. Users can silence the alarm by pressing the “ON” button. Press it again will
●Press the button and hold it for more than 0.5 second to ensure safe operation.
Figure 1
Page 6