Pinnacle Speakers manual Lightning 1000 Installation Guide

Page 23

17

a b

c

d e

4.Network Card. One RJ-45 jack interconnects to the rear panel Network connector.

5.DVE Card. The standard DVE card provides the electronics for Lightning’s layout, GPI, and remote control capabilities. Two 5- Pin “D” connectors are provided. Use the upper connector only.

6.RS-422 Card. This multi-port serial board connects to the four RS- 422 connectors on the rear panel of the chassis via ribbon cables.

7 – 9. Blank Slots.

10.Channel 3 Digital I/O Card (optional). The Channel 3 Digital I/O card (optional) provides the electronics for the second channel’s digital video and key inputs and outputs. Five connectors are provided. See below for details.

11.Channel 2 Digital I/O Card (optional). The Channel 2 Digital I/O card (optional) provides the electronics for the second channel’s digital video and key inputs and outputs. Five connectors are provided. See below for details.

12.Channel 1 Digital I/O Card (standard). The Channel 1 Digital I/O card (standard) provides the electronics for the first channel’s digital video and key inputs and outputs.

Note that the connectors descriptions listed below apply to all three Digital I/O Cards:

a.Key Out. One mini-BNC jack connects to the rear panel Key Out connector for the selected channel.

b.Video Out. One mini-BNC jack connects to the rear panel Video Out connector for the selected channel.

c.Key In. One mini-BNC jack connects to the rear panel Key In connector for the selected channel.

d.Video Out. One mini-BNC jack connects to the rear panel Video Out connector for the selected channel.

e.Reference. For one channel only, one mini-BNC jack connects to the rear panel Reference In and Reference Loop connectors. This jack is only connected on Channel 1’s card and is not used on Channels 2 and 3.

13.Power. The power cable (from the internal power supply) is routed through this hole to the rear AC connector panel.

14.Keyboard. One 5-pin “PS2” jack interconnects to the rear panel Keyboard connector.

15.Mouse. One 5-pin “PS2” jack interconnects to the rear panel Mouse connector.

16.Com 2 (RS-232). This 9-pin connector is an industry-standard RS- 232 port.

Lightning 1000 Installation Guide

Image 23
Contents Installation Guide Copyright Lightning 1000 Installation GuideFCC Compliance Lithium Battery Notice Company Address Power Supply Cord NoticePage Contents Appendix a Specifications Index Software InstallationTip OverviewSecondary Section Documentation ConventionsPrimary Section Documentation Terms Lightning Hardware Welcome to LightningNetworking Lightning SoftwareUser Interface System Inputs and Outputs Remote ControlWord About Windows NT Related Publications TechFAX and WebsiteCompany Address and Phone Numbers This Chapter Hardware InstallationWhat You Will Need Lightning Hardware Chassis DimensionsFigure below illustrates the front of the Lightning chassis Chassis Front ComponentsChassis Rear Panel Components Lightning 1000 Installation Guide Lightning 1000 Installation Guide Chassis Backplane Components Lightning 1000 Installation Guide Chassis Internal Components Scsi Card Ch I/O Card opt Lightning 1000 Installation Guide ShotBox Components PinnacleRear ShotBox Components Lightning Chassis Setup Block DiagramPreparing Your Site Lightning Chassis Power RequirementsUnpacking and Inspection Installing HardwareConnecting Signals Reference Connection Control and Network Connection Input connectionOutput Connection Display Connection GPI Connection ShotBox ConnectionSimplified Schematic of GPI Interface Automation Systems Connections Power ConnectionPower Down Procedure Power Up ProcedureLightning System Interconnect DiagramLightning 1000 Installation Guide Software Description Software InstallationSystem Files and User Files Installing SoftwareThis Appendix SpecificationsLightning 1000 Installation Guide Index SymbolsSDI