Pages

4.Use the UP and DOWN keys to enter how many gallons the tank will hold and press ENTER.

Press EXIT and repeat steps 3 and 4 for each of the remaining tanks.

5.After all tanks on your vessel have been setup, press EXIT repeatedly to be directed back to the main display.

NOTE:

If your LMF-400 was already installed on your boat you likely will not have to complete boat setup. But, if you would like to go through the setup, take a look at the following instructions.

1.Press MENU, scroll down to SYSTEM SETUP, then press ENTER. Select ENG/TANK CFG and press ENTERENTER.

2.The following message will appear: Press Enter to Reset Eng/Tank Cfg. Press ENTER to reset the configuration and be directed to the Boat Setup screen. From the Boat Setup screen, press ENTER to access the engine/tank configuration menu.

Pages are the backbone of the LMF-400. They give you the power to mix and match data that will be displayed on the screen. Once you have picked pages that meet your preferences, the 400's multi-functionality really kicks in, allowing you to customize pages with the data most important to you. We'll take a closer look at customizing pages in Section 5: Advanced Operation.

The LMF-400 has the capability to support up to 16 pages, which means you can add pages you find most helpful more than once, customizing each one differently.

Engine Trim (from left to right), Diagnostics, Fuel Manager and GPS

Module page.

Engine Trim

Monitors position of the boat’s engine in either percentages or degrees. Diagnostics

Monitors engine performance, notifying you if a problem arises. Fuel Manager

Fuel Manager page has three digital readouts capable of displaying: Fuel Flow, Fuel Economy, Fuel Remaining, Fuel Range, Trip Fuel Used, Seasonal Fuel, Paddle Wheel Speed, Pitot Speed and GPS Speed.