To Customize the Quad Analog page:
1.Scroll through the pages set for display by pushing the ENTER or EXIT key.
2.Once the Quad Analog page is displayed, press MENU, select CUSTOMIZE and press ENTER.
3.A menu prompt will appear giving you the option to customize the gauge on the Top Left, Top Right, Bottom Left or Bottom Right.
4.Use the UP and DOWN keys to highlight the gauge you want to customize and press ENTER.
5.Scroll through the device list and highlight the desired item, then press ENTER. This will take you back to the gauge menu prompt. If you want to customize any of the other gauges, repeat the steps above, otherwise press EXIT, EXIT. The information you selected will be displayed on the main screen.
NOTE:
If a page is customized to show information from a device that is working improperly or is not connected to the NMEA 2000 network, the data boxes on the gauge will flash. This indicates the device is not sending data to the Bus. This could occur for a variety of reasons, depending on the device type. If it is a GPS sensor, the GPS unit probably has not locked on to a satellite yet and may take a few moments to acquire a position. All other EP sensors need to be configured, which may be done via Bus Devices in the System Setup menu.
Quad Analog page (left) with Single Digital page (right).
Single Digital
The single digital page displays a single digital gauge that can display: Alt Voltage, Battery Voltage, Engine Temperature, Atmospheric Pressure, Temperature, Depth, Engine Load, Total Engine Hours, Fuel Flow, Fuel Economy, Fuel Remaining, Fuel Range, Paddle Wheel Speed, Pitot Speed, GPS Speed and Tachometer.
33