System Setup

3.Select ON or OFF and press ENTER, which will take you back to the main display.

4.If you choose to keep the current setting, press EXIT to return to the Audio Setup menu

Adjusting Alarm Sounds:

1.To turn on or turn off Alarm Sounds, select ALARM SOUNDS from the Audio Setup menu and press ENTER.

2.Select ON or OFF and press ENTER, which will take you back to the main display.

3.If you choose to keep the current setting, press EXIT to return to the

AUDIO SETUP menu.

4.Press EXIT repeatedly to return to the main display.

On each page, the System Setup menu contains, Engine Displayed, Change Units, Bus Devices, Sonar Alarms, Eng/Tank Configuration, Reset Values and System Information.

To access the System Setup menu, press MENU and use the UP and DOWN keys to highlight SYSTEM SETUP, then press ENTER. We’ll discuss the System Setup menu in more detail in the Advanced Operation section.

Bus Devices

One of the more significant commands in the System Setup menu is the Bus Devices command. It allows you to run a system check for all devices connected to the LowranceNet.

1.To run a system check for devices connected to the NMEA 2000 LowranceNet, press MENU, select SYSTEM SETUP and press ENTER. Choose BUS DEVICES and press ENTER. After a Searching for Bus Devices message comes up, a list of all devices attached to the LowranceNET — the Bus Devices list — will appear.

NOTE:

If you modify settings and are not satisfied with the results, you can reset the gauge to its factory default settings via the Reset Values command.

To Reset Values:

1.Press MENU, highlight SYSTEM SETUP and press ENTER.

2.Scroll down to RESET VALUES and press ENTER. The following message will appear: Press Enter to reset all values.

3.Press ENTER to reset the values.