Lowrance electronic LMF-400 manual

Page 31

1.Scroll through the displayed pages until the Trim Tab page is on the main display.

2.Press MENU, select CALIBRATE TAB and press ENTER, which will launch the following message: Bring Tabs Full Up Press Enter.

3.Adjust the position of the Trim Tabs to the Full Up Position and press ENTER. A second message will appear: Run Tabs Full DN (Down).

4.Move the Trim Tabs into the full down position. The Trim Tabs are now calibrated. Recalibration can be performed at any time and as many times as necessary by following the step by step trim tab calibration instructions listed in this section.

Trim Tabs menu (left). When calibrating Trim Tabs, the Full Up message (center) appears first. It is followed by the Run Tabs Full Down message (right).

29

Image 31
Contents LMF-400 Copyright 2005 Lowrance Electronics, Inc All rights reserved Table of Contents To unconfigure Fluid Level Calibrate Introduction Page Mounting the Unit PreparationPage Nmea 2000 network node located at the end of a Nmea 2000 bus Page Operation Boat SetupPages Page Basic Menu Viewing optionsPage Page Screen Press Exitexit to return to the main display Audio SetupSystem Setup Page EP Configuration Calibration Unconfigure or Reconfigure Page Fluid Level Enter To configure Waste Water Page Calibration of EP Devices Page Recalibrate option Page Page Single Analog Customizing PagesQuad Analog Dual AnalogSingle Digital Dual Digital Trim Tabs Quad DigitalFuel Manager GPS PositionPage System Setup Menu Enter Page Change Units Enter Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site