NovaJet PRO 600e
Note: Visually inspect each cartridge before installing. Make sure the blue tape is intact on the jet area of the cartridge. (Do not remove the tape at this time as the cartridge could leak! The tape will be removed later after negative pres- sure has been established by priming the ink delivery lines.) Inspect the IC chip on the cartridge. Make sure it is secure and in approximately the location shown on the following figure. If any cartridge is damaged, contact your authorized ENCAD distributor/dealer for return/replacement of the defective cartridge.
➪To install the ink cartridges
!Do not touch the jet area or the flex contact area of the ink cartridge.
!Work with only one ink color at a time to prevent contamination.
1With printer power on, press Utility/Access Cartridges to move the carriage to the position which allows replacement of the ink cartridges.
2Cartridges are prefilled and preprimed. Remove the cartridge from the sealed bag and remove the shipping cap.
3Install the cartridge bottom first into the correct slot on the carrier. DO NOT REMOVE THE BLUE TAPE FROM THE JET PLATE. Tilt the cartridge up until it clicks into place. Make sure the cartridge is firmly seated.
14 Quick Start