NovaJet PRO 600e
3Press Utility/Access Cartridge to move the carriage back into the service station. This ensures that the cutter blade is in the home position.
Filling the ink reservoirs
The printer can support long, uninterrupted printing runs because of the large capacity of each of the four ink reservoirs. The ink reservoirs are located in the printer's left side cover.
Note: When running at carriage speeds faster than the default, it is recom- mended that ink levels in the reservoirs be no more than 300ml maximum.
ENGLISH
➪To fill the ink reservoirs
1Open the cover on the left side of the printer to access the ink reservoirs. Unscrew and remove the cap of one reservoir. Open only one reservoir at a time to prevent contamination with other ink colors.
2Make sure the ink color and type matches the reservoir and pour in the ink. Do not add more than 400 ml of ink or fill higher than 1/2 inch from top of the reservoir. Be sure to use the same type of ink (i.e., GA, GS, or GO) in all the reservoirs and ink cartridges. Be sure there is no excess ink on the inside of the reservoir cap. Replace the cap loosely on the reservoir - do not overtighten.
3Your printer comes standard with two complete sets of plumbing for easy changeover between two ink sets. Each of these lines has color coded quick connect fittings. Be sure that each reservoir is connected to the same color fitting. To change reservoirs, simply snap into the appropriate fittings.
4Repeat for the remaining reservoirs, then close the cover.
Installing the ink cartridges
The printer is designed to use only ENCAD PRO 600e series cartridges. It is not compatible with NovaJet, NovaJet Pro, or NovaJet PROe cartridges. Use of other cartridges may damage the printer and/or prevent it from printing and void the warranty.
Be sure all cartridges and reservoirs use the same ink type; i.e., PRO 600e series GA, GS, or GO.
Quick Start 13