La Crosse Technology WS-7136U instruction manual

Page 24

3)Once the system has been reset and you have a temperature reading from the sensor, temporarily place the remote temperature sensor in the previous location.

Note: If there is an outdoor temperature displayed when the two units are close together there was either too much distance between the two units previously or some type of interference that was causing poor reception.

4)If after 15 minutes the temperature is not displayed you will need to choose another location for placement of the temperature sensor.

5)The best way of doing this is to move the sensor 10 feet closer to the indoor temperature station.

6)After moving the remote temperature sensor please wait 15 minutes to give the indoor temperature station time to re- acquire the signal.

24

Image 24
Contents WS-7136U Wireless 433 MHz Temperature Station Table of Contents Inventory of Contents IndoorAdditional Equipment not included Quick Setup Do not Press ANY Buttons for 15 MinutesPage Page Page Press and release the SET button once more and you are done Battery Indoor Temperature Station II. Programming Sequence III. Setting the Time Format IV. Setting the Temperature FormatSetting the Time Page Features Minimum and Maximum Temperatures Adding Additional Remote Temperature Sensors Optional Resetting the Minimum and Maximum TemperaturesPage Page Viewing and Operating with Multiple Remote Sensor Units Mounting Remote Temperature Sensor Temperature Station Troubleshooting SolutionPage Page Maintenance and Care Instructions Specifications Measuring Range TemperatureIndoor AAA Temperature Station Page Page FCC Disclaimer FCC ID OMO-01RX Receiver OMO-01TX Sensor