La Crosse Technology WS-7136U instruction manual Indoor Temperature Station

Page 11
Battery cover
Battery Compartment

B. INDOOR TEMPERATURE

STATION

Note: After the batteries are installed, DO NOT press any buttons for 15 minutes. This may interfere with the signals, causing temperatures to register incorrectly.

1.Remove the battery

cover on the backside. To do this, push up and pull out.

2. Observing the correct

polarity, install 2 AAA batteries.

3.Replace battery cover.

4.Wait 15 minutes or until both the indoor and outdoor temperatures are shown on the indoor temperature station.

5.The indoor temperature station should now show: “-:- -” in the TIME LCD,

11

Image 11
Contents WS-7136U Wireless 433 MHz Temperature Station Table of Contents Indoor Inventory of ContentsAdditional Equipment not included Do not Press ANY Buttons for 15 Minutes Quick SetupPage Page Page Press and release the SET button once more and you are done Battery Indoor Temperature Station II. Programming Sequence IV. Setting the Temperature Format III. Setting the Time FormatSetting the Time Page Features Minimum and Maximum Temperatures Resetting the Minimum and Maximum Temperatures Adding Additional Remote Temperature Sensors OptionalPage Page Viewing and Operating with Multiple Remote Sensor Units Mounting Remote Temperature Sensor Temperature Station Solution TroubleshootingPage Page Maintenance and Care Instructions Measuring Range Temperature SpecificationsIndoor AAA Temperature Station Page Page FCC Disclaimer FCC ID OMO-01RX Receiver OMO-01TX Sensor