La Crosse Technology WS-7136U Press and release the SET button once more and you are done

Page 9

and release the “SET” button once.

3.An hour will now be flashing.

a.Press and release the “RESET/+” button until the correct hour is shown.

Note: When in the 12h mode “PM” is displayed in the upper left corner of the display between noon and midnight. During the AM hours this area will be blank.

b.When the correct hour is shown, press and release the “SET” button once.

4.A minute will now be flashing.

a.Press and release the “RESET/+” button until the correct minutes are displayed.

Press and release the SET button once more and you are done.

9

Image 9

Contents WS-7136U Wireless 433 MHz Temperature Station Table of Contents Indoor Inventory of ContentsAdditional Equipment not included Do not Press ANY Buttons for 15 Minutes Quick SetupPage Page Page Press and release the SET button once more and you are done Battery Indoor Temperature Station II. Programming Sequence IV. Setting the Temperature Format III. Setting the Time FormatSetting the Time Page Features Minimum and Maximum Temperatures Resetting the Minimum and Maximum Temperatures Adding Additional Remote Temperature Sensors OptionalPage Page Viewing and Operating with Multiple Remote Sensor Units Mounting Remote Temperature Sensor Temperature Station Solution TroubleshootingPage Page Maintenance and Care Instructions Measuring Range Temperature SpecificationsIndoor AAA Temperature Station Page Page FCC Disclaimer FCC ID OMO-01RX Receiver OMO-01TX Sensor